Content Comparison

...

Remote ID or RID has been mandated by the FAA for commercial operations, and its inclusion means there are a few additional things to be aware of when preparing for a flight.

• There is The drone contains a transmitter in the drone that communicates with the Ground Control Station (GCS), also known as the controller.

• In order to fly, RID To operate, Remote ID (RID) requires location data for both the Pilot (handled provided by the GCS) and for the Drone itself.

• With WisprGroundControl 1.6.0, improvements have been made to make the experience of getting past pre-arm messages smoother. Users should spend much less time before being able to launch, and in ideal scenarios will not see any RID pre-arms during bootupWisprGroundControl has been optimized to streamline the pre-arm process, reducing delays before launch. In ideal conditions, pilots should experience minimal or no RID pre-arm messages during system boot-up.

• To avoid errors that can be caused by the GCS determining its location from a combination of sources, setting your location service to “Device Only” is the new protocol for the controllers.

  • To do this, drag from the top of your controller screen and hold down the location icon shown circled below.

    Image Removed

  • You will see a “Mode” option.

  • Select it, this option and choose “Device Only”.

    Image Added

• Additionally,

  make sure

  ensure that your controller is set to United States (for US-based

  customers

  users) in the Herelink Settings.

  This can be accessed by tapping the grid

• To do this : Tap the Applications icon in the bottom-right corner of your home screen

  , and opening

  . (9 small squares)

  • Open the Herelink Settings app, which is represented by a green Gear icon gear icon.

  • Ensure United States is selected

  • If United States is not seleted, tap the down arrow beseide the country selected (seen below) and select United States.

  • 

Pre-arms

• OpenDroneID: waiting on controller location

  • This message appears when the system has connected to the controller, but the controller hasn't determined its location yet. Once the location is found, the message will disappear. Once location is found it should not be lost as long as WisprGroundControl remains open.

• Controller Location Lost:

  • This indicates the GCS’s location was lost. In normal use the user should not encounter this message unless they change apps or restart WisprGroundControl. In such case the controller should still pull its location soon if signal is strong enough and the message will clear.

• Waiting on Initialization:

  • This message means that the system hasn't yet received any information from the controller. It should only appear for a few seconds while the connection is being set up.

    • On rare occasion the RemoteID module may not transmit signal promptly enough and cause this error to not clear normally, but is not cause for concern. To resolve it, please close WISPRGroundControl, reboot the drone, and then reopen WISPRGroundControl. The Pre-arm error should no longer be present.

...