How to Set Your UAS ID

Update WISPR Ground Control to v1.5.0 and update WISPR Flight Firmware to v1.5.0.

Power Ranger Drone on and Open WISPR Ground Control on your controller.

Let paramerts load completly on WISPR Ground Crontrol. Select the W in the top left of the screen and click Settings -> Safety -> FAA Registration.

Enter your UAS ID(which will be found on the label, located on the side of the drone. If there is a UAS ID saved in that spot already in settings (on the controller), please confirm it matches the UAS ID label on the side of your drone.

1. If there is a UAS ID in the slot, it should be greyed out and not let you change it.

Press“Set UAS ID” button to confirm you have entered the the drone UAS ID.

1. Once you press this a slide out will ask you to confirm your UAS ID has been entered correctly. Ensure the ID is correct (it cannot be changed) and select “YES”

2. Press Control on the left menu bar and scroll to the bottom. You will see WISPR Ground Control version, Wispr Flight Firmware version and the Drone Serial Number. Ensure these are all correct.

Reboot the drone and you have now set the UAS ID!