...
Download the .zip folder under the “Wispr “WISPR Ground Control and Wispr WISPR Flight Firmware - Remote ID” section in our Downloads page.
Extract the zipped file. You must extract the files or the update will not work.
Plug a USB cable from your laptop/PC and connect it to the Flight Controller configuration port.
...
Open Mission Planner.
If Mission planner is not installed on your computer, please visit Installing Mission Planner — Mission Planner documentation to download the latest version.
Once opened, connect to Mission Planner by selecting Auto in the top right corner of the drop down and selecting connect. Allow the parameters to load and you should see connect button in the top right of Mission Planner change to disconnect, ensuring you are now connected to mission planner.
Select the Setup tab on the top bar, then install firmware, then bootloader update.
Two pop ups will appear after selecting this. Select Yes on both pop ups.
Once the bootloader has finished updating, a pop-up box will appear that says “Upgraded Bootloader”. Select OK. Your bootloader is now updated!
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
This is a CRITICAL warning. Once you have chose chosen to update the bootloader, DO NOT unplug the USB cable from the computer nor the Flight Controller on the drone. Unplugging or disconnecting while the bootloader is updating could cause your flight controller to become non-responsive. |
...
Connect your USB cord from your computer to the port on the bottom of your hand controller
Open the UNZIPPED folder you downloaded from the downloads page and select the Windows folder → windows-update. This will update your Wispr WISPR Ground Control to 1.0.0
...
Press 'Y' when prompted. Allow the script to run until you see “Successfully updated application! Press any key to continue…” The application is
...
Power on drone IN A SAFE AREA and open Wispr WISPR Ground Control.
a. Open General settings and navigate to the Remote ID section.
...
e. Reboot your drone, and restart Wispr Ground WISPRGround Control. After parameters load you may power off the drone.
...