Versions Compared

Old Version 35

changes.mady.by.user Conor Ferguson

Saved on

compared with

New Version Current

changes.mady.by.user Bryan Cubbins

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Sony 24 Mapper

What should be done if the video feed is not showing on my Fly View screen in WISPR Ground Control?

  • Check the Camera Lens

    • Ensure that the camera lens cover is removed.

  • Verify Camera Power

    • Confirm that the camera is powered on by toggling the switch located on top of the camera.

  • Inspect Camera Mounting and Gimbal Position

    • Ensure the camera is securely mounted.

    • Verify that the gimbal is in the Follow Mode position. In this mode, the gimbal should remain locked in a forward-facing position and not sway freely.

  • Confirm Gimbal Status

    • A blue LED light should be visible at the back of the gimbal, indicating it is in Follow Mode.

  • What should be done before flying with this payload?

    • Ensure the correct payload is selected in WISPR Ground Control.

    • BEFORE EACH FLIGHT : Twist the focus ring located on the lens to infinity.

What overlap can be used while flying a mission with this payload?

...

  • Please see the picture below for reference.

Spacing in pictures.jpg

...

Gremsy Vio

Info

General Information:

  • Normally when connecting with a Vio, you will see an initial parameter bar load, disappear for a few seconds, and then return, but in a state where it appears to be almost done while not moving.

    • When you see this, the Vio is downloading its parameter list. Sometimes you may see “Mount: Not Healthy” appear on screen before they load.

    • You can verify that this is occurring by tapping the megaphone icon and looking for “Info: Mount: GREMSY VIO fw:7.7.5.0”.

    • With some Vio’s it has been observed that the Vio can either take more time than typically expected to begin booting, pulling its parameter list, or both.

      • This may appear as the camera remaining limp for longer than one expects, or the initial parameter bar appearing to fully finish, but not return.

      • Allow a couple of minutes for the process to conclude. There have been instances where it appeared the payload is not working, but simply took longer to initiate.

I only have partial control with the Zio or Vio. Zoom does not work, nor does stream swap between normal and thermal vision for the Vio.

...