Page Comparison

...

Sony ILX-LR1 due to the lack of RTC which causes the camera to sometimes reset language, date, and time settings. For those that this happens to this is the fix to solve this issue.

To remove the error do The error has been corrected by installing WGC 1.7.2 or higher. With the ILX-LR1 payload selected, there will be an option on the same tab (PAYLOADS) where you can press “Reset Time/Time” followed by the focus button (infinity looking symbol at the bottom right corner when viewing the camera display). The WGC change log can be found here: WISPR Ground Control and WISPR Flight Firmware Release Changelog

Another method to remove the error can be achieved by the following:

• Download the MavCam App zip folder below and save it on your PC.

...

• Transfer the MavCam file onto a microSD card.

• Insert the microSD card into the slot located at the bottom of the smart controller. The SD slot is positioned to the left of the charging port.

• Press the nine (9) boxes at the bottom right hand corner of the controller’s home screen. Navigate to the "GalleryDownloads" within your applications. Locate the SD card file.

• Open the SD card file and find the MavCam .apk file. Click on it to begin the installation process.

• During installation, the app will request permission to overlay on other applications. Enable the corresponding toggle to grant this permission.

• MavCam is now installed and should now be present as an app in your applications on your controller.

• Soft press once to open and run MavCam from your applications.

• You should now see the MavCam controls displayed at the bottom of the screen.

...

• Open WISPR Ground Control (with your ILX connected and -LR1 on the drone. Power on the drone powered).

• Allow the parameters to fully download.

• Swipe the camera/video icons upward to reveal the MavCam Controls panel.

...

• Select 1.Area/Date.

• Press down once and select Area/Date/Time Setting.

• Select "Area Setting" and ensure the region is set to your correct region. In Mississippi we are selecting "Chicago/Mexico CityCity” in the example. "

• Press the down arrow again and select "Daylight Savings." Switch this setting from "Off" to "On" by tapping the circle next to "ON."”

• Navigate down once more using the arrow keys and select "Date/Time." Use the right directioanl directional arrow to navigate to hours/minutes/seconds and use the up and down directional arrows to input the correct time.

• Once complete, press the back arrow twice, then scroll down to "Reset/Save Settings" and select "Save/Load Settings."

• Press Ok.

• Select "Save" and then choose "Save New."

• Your settings are now successfully saved!

• If you would like to Uninstall MavCam once complete, navigate to your applications and long press on the MavCam application until a pop up (as seen below) is shown.

...