Page Comparison

...

• Copy Transfer the MavCam file onto a micro SD microSD card.

• Insert the microSD card into smart controller slot found on the slot located at the bottom of the smart controller. The SD slot is positioned to the left of the charging port on the controller.Once inserted, go into gallary inside of your applications and look for .

• Navigate to the "Gallery" within your applications. Locate the SD card file.

• Once in Open the SD card file and find the MavCam .apk file. Click to installon it to begin the installation process.

• The During installation, the app will request permission to overlay on other applications, and you will need to enable . Enable the corresponding toggle to allow grant this functionalitypermission.

• MavCam is now installed and should now be present as an app in your applications on your controller.

• Open Soft press once to open and run MavCam from your applications.

• You should now see the MavCam controls displayed at the bottom of your the screen.

• Slide with your finger Swipe the camera/video icon to the right to bring access the MavCam Configuration screen up. Check the box “Auto start MavCam” and then exit out by pressing the X in the top rightSelect the checkbox labeled "Auto Start MavCam," then exit the screen by tapping the "X" in the upper-right corner.

...

• Open WISPR Ground Control (with your ILX connected and the drone bootedpowered)

• Allow the parameters to fully download

• Swipe the Cameracamera/Video video icons straigh up upward to show reveal the MavCam Controls panel.

• Press the "OK" button in located at the middle center of the four directional arrows . This will to display the camera’s camera's icons and settings.

• Use the arrow keys to navigate to the briefcase icon

• Select 1.Area/Date.

• Press down once and select Area/Date/Time Setting.

• Select "Area Setting" and ensure it is on the region is set to "Chicago/MexicoCityMexico City."

• Press the down once more arrow again and select "Daylight Savings. Turn " Switch this setting from "Off" to "On" by touching tapping the circle beside next to "ON."

• Go Navigate down once more using the arrows arrow keys and select "Date/Time. Navigate right and put in your " Use the right arrow to input the correct time.

• Once setcomplete, press the back arrow twice and go down one option to , then scroll down to "Reset/Save Settings. Select " and select "Save/Load Settings."

• Press Ok.

• Select "Save" and then choose "Save New."

• Your Settings settings are now successfully saved!

• If you would like to Uninstall MavCam once complete, navigate to your applications and hold your finger down long press on the MavCam application (Long Press) until a pop up (as seen below) is shown.

...

• Select Unstall appUninstall App. When prompted “Are with the message, "Are you sure? MavCam will be uninstalled.” Press OK and MavCam has now been ," press OK to confirm. MavCam will then be successfully removed from your controller.

...