...
Never go above 70/70 overlap when you plan a mission with this payload.
Sony ILX-LR1
Why are there spaces in between my photos when watching my mission?
It is entirely normal to observe a small gap between pictures immediately after a turnaround or loop. This is an intentional design choice due to the high-resolution cameras. Additional photos are not required immediately after a turnaround. In every other line, you will notice the images closely aligned. Two pictures are taken quickly allowing for spacing between the next row on turn around. After completing a turnaround, the camera resumes its regular spacing. This practice is implemented to enhance efficiency and to prevent inaccurate geotags on closely positioned images or those taken during turns.
Please see the picture below for reference.
Zio and Vio
General Information:
Normally when connecting with a Vio, you will see an initial parameter bar load, disappear for a few seconds, and then return, but in a state where it appears to be almost done while not moving. When you see this, the Vio is downloading its parameter list. Sometimes you may see “Mount: Not Healthy” appear on screen before they load.
You can verify that this is occurring by tapping the megaphone icon and looking for “Info: Mount: GREMSY VIO fw:7.7.5.0”.
With some Vio’s it has been observed that the Vio can either take more time than typically expected to begin booting, pulling its parameter list, or both. This may appear as the camera remaining limp for longer than one expects, or the initial parameter bar appearing to fully finish, but not return. Allow a couple of minutes for the process to conclude. There have been instances where it appears the payload is not working, but simply took longer to initiate.
...
I only have partial control with the Zio or Vio. Zoom does not work, nor does stream swap between normal and thermal vision for the Vio.
First, try simply rebooting the drone and WGC. There have been one or two instances where the Vio . This appeared to pull its parameters yet lacked full functionality, but was resolved with a restart.
If this issue persists, it can be fixed by:
Completely uninstalling WISPRGroundControl then reinstalling
Booting the drone, connecting to WISPRGroundControl , and setting the payload to Vio
Reboot both the drone and WISPRGroundControl, allow the param bar to fully load the Vio firmware.
Reboot both again, and after the parameters are finished loading you should have full control.
...
Select Vio as your payload in WGC before booting (so you do not have to reboot after)
Connect your Vio to the quick attack via the gimbal
Power on the drone and open QGroundControl and allow parameters to load fully
Once loaded close QGroundControl and open WisprGroundControl, allow parameters to load and you should have a working stream and you will have full function of the roll wheel.
Sony ILX-LR1
Why are there spaces in between my photos when watching my mission?
...
.
...
Please see the picture below for reference.
...