Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • Completely uninstalling WISPRGroundControl then reinstalling

  • Booting the drone, connecting to WISPRGroundControl , and setting the payload to Vio

  • Reboot both the drone and WISPRGroundControl, allow the param bar to fully load the Vio firmware.

  • Reboot both again, and after the parameters are finished loading you should have full control.

I have no roll wheel control on the Vio.

  • Select Vio as your payload in WGC before booting (so you do not have to reboot after)

  • Connect your Vio to the quick attack via the gimbal

  • Power on the drone and open QGroundControl and allow parameters to load fully

  • Once loaded close QGroundControl and open WisprGroundControl, allow parameters to load and you should have a working stream and you will have full function of the roll wheel.

Sony ILX-LR1

Why are there spaces in between my photos when watching my mission?

It is entirely normal to observe a small gap between pictures immediately after a turnaround or loop. This is an intentional design choice due to the high-resolution cameras. Additional photos are not required immediately after a turnaround. In every other line, you will notice the images closely aligned. Two pictures are taken quickly allowing for spacing between the next row on turn around. After completing a turnaround, the camera resumes its regular spacing. This practice is implemented to enhance efficiency and to prevent inaccurate geotags on closely positioned images or those taken during turns.

  • Please see the picture below for reference.

Spacing in pictures.jpgImage Added