Page Comparison

1. Update your WISPR Ground Control to V1.5.0 and update WISPR Flight Firmware to V1.5.0.

2. Power Ranger Drone and Open WISPR Ground Control on your controller.

3. Let

...

1. paramerts load completly on WISPR Ground Crontrol then select the W in the top left of the screen and click Settings -> Safety -> FAA Registration.

2. Enter your UAS ID(which you can find on the label on the side of the drone. If there is a UAS ID in that spot already, please confirm it matches the UAS ID label on the side of your drone.

   1. If there is a UAS ID in the slot, it should be greyed out and not let you change it.

3. Operator ID should be WisprSystems.

4. Press“Set UAS ID” button to confirm you have entered the the drone UAS ID.

   1. Once you press this a slid out will ask you to confirm your UAS ID has been entered correctly. Ensure the ID is correct (it cannot be changed) and select “YES”

   2. Press Control on the left menu bar and scroll to the bottom. You will see the drone WISPR Ground Control version, Wispr Flight Firmware version and the Drone Serial Number. Ensure these are all correct.

5. Reboot the drone and you have now set the UAS ID!

...